Extreme Networks ExtremeWare Command Reference Manual page 305

As the module progresses through its initialization, the
general purpose processor (GPP) subsystem change state to OPERATIONAL, and then each of the
network processors will change state to OPERATIONAL.
When the GPP subsystem completes its initialization cycle and the subsystem state is
OPERATIONAL, use the
module power-on self test (POST).
If the STATUS LED on the ARM, ATM, MPLS or PoS module turns amber and blinks, use the
slot <slot>
displays operational information related to the ARM, ATM, MPLS or PoS module. Information
displayed includes the BlackDiamond switch fabric card state, Network Processor status, General
Purpose Processor status, hardware serial number and type, and image version and boot settings.
For the ARM, ATM, MPLS, PoS, and WAN modules, the information displayed by this command
includes data about the software images loaded on the module and information about the operational
status and backplane connections of the module.
Example
The following example displays module information for all slots:
show slot
Following is the output from this command:
Slot 1 information:
State:
Serial number:
HW Module Type:
Configured Type:
UTP ports available:
Link Active:
Link Down:
Slot 2 information:
State:
Serial number:
HW Module Type:
Configured Type:
Gigabit ports available:
Link Active:
Link Down:
GBIC missing:
Slot 3 information:
State:
Serial number:
HW Module Type:
Configured Type:
Gigabit ports available:
ExtremeWare Software 7.3.0 Command Reference Guide
show diagnostics {<slot>}
command to display the slot status information. The
Operational
701028-06-0026F38445
G8Ti
Not configured
01 02 03 04 05 06 07 08
Operational
701024-19-0125F06190
G8Xi
Not configured
01
02 03 04 05 06 07 08
Operational
701020-11-0032F51006
G12SXi
Not configured
command displays the
show slot <slot>
command to check the results of the
show slot <slot>
show slot
show
command also
305