Show Vlan Dhcp-Config - Extreme Networks ExtremeWare Command Reference Manual

Commands for Managing the Switch

show vlan dhcp-config

show vlan <vlan-name> dhcp-config
Description
Displays the DHCP configuration for a specified VLAN.
Syntax Description
vlan-name
Default
If no VLAN name is specified, summary information is displayed by default or all VLANs on the
device.
Usage Guidelines
This command displays the DHCP configuration for the specified VLAN.
With the multinetting feature it is possible to configure DHCP address ranges belonging to the local
subnet (primary subnet/secondary subnet) and also remote subnets. The output for this command has
groups and displays DHCP address ranges (Primary DHCP Address Range followed by Secondary and
Remote Subnet Ranges). In addition, the output displays lease timer values in the beginning of the
output ("Netlogin Lease Timer: (and) DHCP Lease Timer:")
Example
The following example shows output for the
named vlantest3 is configured with a primary DHCP address range, a secondary subnet DHCP address
range, and is also configured to provide addresses for a remote subnet.:
show vlan vlantest3 dhcp-config
Following is sample output from this command:
Netlogin Lease Timer:
DHCP Lease Timer:
Primary DHCP Range:
Secondary DHCP Range 1:
Remote DHCP Range:1
Ports DHCP Enabled:
History
The output for this command has been changed to accommodate the multinetting feature by including
DHCP address ranges for primary/secondary and remote subnets. This modified command was made
available in ExtremeWare 7.3.0.
214
Specifies the name of the VLAN for which the DHCP configuration is to be
displayed. If no VLAN name is specified, summary configuration information is
shown for all VLANs on the device.
show vlan dhcp-config
Not configured(Default = 10 secs)
Not configured(Default = 7200 secs)
11.3.3.5->11.3.3.20
11.4.3.5->11.4.3.20
99.0.0.5->99.0.0.10
25
command, where the VLAN
ExtremeWare Software 7.3.0 Command Reference Guide