Enable Flowstats Filter Ports - Extreme Networks ExtremeWare Command Reference Manual

enable flowstats filter ports

enable flowstats filter <filter#> ports <portlist> {ingress | egress}
Description
Enables a specified flow record filter for the specified ports.
Syntax Description
filter#
portlist
ingress
egress
Default
For the PoS module, filter #1 is enabled on all SONET ports, and the remaining filters are disabled.
For other switches or modules, filters are enabled by default when they are configured.
Usage Guidelines
The # parameter is an integer in the range [1-8]. A filter must be enabled to match a flow. For "i"
filter
series devices other than the PoS module, these apply to outbound flows only.
For each SONET port on a PoS module, sixteen filters are supported—eight filters for ingress flows and
another eight filters for egress flows. The
keyword are used to identify the particular filter that is being disabled.
One of either the
Example
The following command enables filter 3 for ports 1-8 on the switch:
enable flowstats filter 3 ports 1-8
History
This command was first available in ExtremeWare 6.1.5b20 for the PoS module only.
This command was first available in ExtremeWare 6.2 for all "i" series platforms.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies the flow record filter that should be enabled.
Specifies the ports or slots and ports for which the filter should be enabled.
May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
Use this keyword to specify that the filter being enabled or disabled is one of
the eight filters to be applied to inbound flows on the SONET port(s).
Supported on the PoS module only.
Use this keyword to specify that the filter being enabled or disabled is one of
the eight filters to be applied to outbound flows on the SONET port(s).
Supported on the PoS module only.
filter
or keywords are required for SONET ports.
ingress egress
# parameter and either the
enable flowstats filter ports
or
ingress egress
689