Extreme Networks ExtremeWare Command Reference Manual page 686

Commands for Status Monitoring and Statistics
For ExtremeWare 6.2.2b108:
The default for the transceiver test is enabled. The test is enabled two minutes after the switch boots or
immediately after you enable the test.
For ExtremeWare 6.2.2b134 and ExtremeWare 7.1.0:
The default for the transceiver test is disabled. If you load your saved ExtremeWare 6.2.2b108
configurations onto a switch with ExtremeWare 6.2.2b134 or ExtremeWare 7.1.0 or later, the transceiver
test is enabled. You must manually disable the transceiver test if you want the feature disabled.
Example
The following command disables the transceiver test on slot 4 of a modular switch:
disable transceiver-test slot 4
History
This command was first available in ExtremeWare 6.2.2b108.
The default for this command was changed to disabled in ExtremeWare 6.2.2b134.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available on modular switches only.
686 ExtremeWare Software 7.3.0 Command Reference Guide