Configure Enhanced-Dos-Protect Ports - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

configure enhanced-dos-protect ports

configure enhanced-dos-protect ports [trusted | untrusted] <portlist>
Description
Configures ports as trusted, so that enhanced denial of service protection is not applied to the ports; or
configures ports as untrusted, so that enhanced denial of service protection is applied to the ports.
Syntax Description
trusted
untrusted
portlist
Default
By default, ports are trusted.
Usage Guidelines
You can configure each port as trusted or untrusted. A trusted port behaves as a normal port. An
untrusted port behaves according to the configuration parameter used in IPFDB thrashing.
Verify the status of each port by using the
command.
ports <portlist>
Example
The following command configures a range of ports as trusted, so that enhanced denial of service
protection is not applied to ports 2 through 4:
configure enhanced-dos-protect ports trusted 2-4
History
This command was first available in ExtremeWare 7.3.0
Platform Availability
This command is available on all platforms.
786
Specifies the selected ports as trusted, so that enhanced denial of service is
not applied to the ports.
Specifies the selected ports as untrusted, so that enhanced denial of service
is applied to the ports.
Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
show enhanced-dos-protect [rate-limit | ipfdb]
ExtremeWare Software 7.3.0 Command Reference Guide