Extreme Networks ExtremeWare Command Reference Manual page 101

• NVRAM configuration information (primary/secondary configuration, date/time, size, version)
• PACE configuration information
• Software licensing information
• MSM information (BlackDiamond switch only)
• Mode of switch operation (Alpine 3802 only)
• Default configuration mode (standard or enhanced)
This information may be useful for your technical support representative if you have a problem.
Depending on the software version running on your switch, additional or different switch information
may be displayed.
Example
The following command displays current switch information:
show switch
Output from this command looks similar to the following:
SysName:
SysLocation:
SysContact:
System MAC:
License:
System Mode:
RED Probability:
DLCS:
SysHealth Check:
Recovery Mode:
Transceiver Diag: Enabled.
Fdb-Scan Diag:
System Watchdog:
Reboot Loop Prot: Disabled
Current Time:
Timezone:
Boot Time:
Config Modified:
Next Reboot:
Timed Upload:
Timed Download:
Temperature:
Power supply:
Image Selected:
Image Booted:
Primary EW Ver:
ExtremeWare Software 7.3.0 Command Reference Guide
Alpine3804
Extreme Networks HQ
Carlos_Beronio
00:01:30:23:C1:00
Full L3
802.1Q EtherType is 8100 (Hex).
0
Enabled
Enabled. Alarm Level = Log
All - System-dump/Reboot
Failure action:
Enabled. Failure action:
Enabled
Tue Jun 10 07:39:40 2003
[Auto DST Enabled] GMT Offset: 0 minutes, name is GMT.
DST of 60 minutes is currently not in effect, name is not set.
DST begins every first Sunday April at 2:00
DST ends every last Sunday October at 2:00
Wed Jun 4 11:52:38 2003
Mon Jun 9 15:09:44 2003
None scheduled
None scheduled
None scheduled
Normal. All fans are operational.
Upper (PSU-A) not present,
Primary
Primary
7.0.0b61 [unknown-ssh]
CPU Tx-Priority = High
log only
log only
Lower (PSU-B) OK
show switch
101