Extreme Networks ExtremeWare Command Reference Manual page 806

Security Commands
remove
add | delete <med_number>
local-preference <number>
weight <number>
origin [igp | egp | incomplete]
tag <tag_number>
accounting index
<index_number>
value <value_number>
cost <number>
cost-type <number>
Default
N/A.
Usage Guidelines
Route map statements are evaluated after
set
Changes to the route maps used to modify or filter NLRI information exchanged with neighbors is
immediately effective on the routing information exchanged after the policy changes. The changes can
be applied on the NLRI information that had been exchanged before the policy changes by issuing a
soft reset on the ingress or egress side, depending on the changes. For soft resets to be applied on the
ingress side, the changes must be previously enabled on the neighbor.
Changes to the route maps associated with network aggregation or redistribution commands becomes
effective after a maximum interval of 30 seconds. You can immediately apply them by using the soft
reconfiguration command.
Example
The following command modify the routing information for a route that matches a statement in entry
15 of route table bgp-out include a MED value of 200:
configure bgp-out 15 add set med 200
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
806
Removes the MED attribute, if present.
Adds or deletes the specified value to or from the MED that is received. The
final result is bound by 0 and 2147483647.
Sets the local preference in the path attribute to the specified local preference
number.
Sets the weight associated with the NLRI to the specified number.
Sets the origin in the path attributes to the specified origin.
Sets the tag in the route to the specified number.
Specifies the index number of an accounting index to be set.
Specifies the value to which the accounting index should be set.
Sets the cost of the route to the specified number.
Sets the cost type associated with the route (ase-type-1 or ase-type-2).
statements, but before the
match
statement.
goto
ExtremeWare Software 7.3.0 Command Reference Guide