3.4.2 Interface Commands - Comtech EF Data CDM-570L Installation And Operation Manual

Command Arguments
Parameter (Instruction for Command
Type Code and or Response
Qualifier)
Enable/Disable QSE= 1 byte value
QoS Feature 0 – Disable
1 – Enable
System None String of
Configuration Variable byte
Get size

3.4.2 Interface Commands

Command Arguments
Parameter (Instruction for Command
Type Code and or Response
Qualifier)
Ethernet MAC NONE 12 bytes
Ether speed ESM= 1 byte, value
mode of 1..5
Page 15 of 54 21
Description of Arguments
to Query
Command or Query.
Setting this to '1' enables the Quality of Service feature.
Setting to '0' disables it.
Query only.
Querying the SCG? Dumps the system configuration. This can be
used for updating the GUI parameters. See the Appendix section
for more information on individual field.
Description of Arguments
to Query
Query only.
Returns the Ethernet MAC address, format:
Example: ETM=0006B0000178
Command or Query.
1 -- Auto
2 -- 10 MB/sec Half Duplex
3 -- 100 MB/sec Half Duplex
4 -- 10 MB/sec Full Duplex
5 -- 100 MB/sec Full Duplex
Specifies the speed and mode of Ethernet interface.
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
QSE= QSE? QSE=x
QSE!
SCG= SCG? SCG= string of variable
SCG! byte size.
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
ETM! ETM? ETM=xxxxxxxxxxxx
(see description of
arguments)
ESM = ESM? ESM = x
ESM! (see description of
arguments)
MN/CDM570L.AA4