Comtech EF Data CDM-570L Installation And Operation Manual page 26

Command Arguments
Parameter (Instruction for Command
Type Code and or Response
Qualifier)
IP Address of IPA= 15 bytes
Ethernet length.
interface
IP Address IPM= Value of
Mask of 8 – 32
Ethernet
Interface
HDLC HAD 4 bytes,
Address Numerical
Page 14 of 54
Description of Arguments
to Query
Command or Query.
Used to set the IP address and mask of the Ethernet interface, in the
format:
xxx.xxx.xxx.xxx
where xxx.xxx.xxx.xxx is the IP addresss
Example: 010.006.030.001
Note: To make the IPA= command effective, one needs to issue the
IPM command immediately following IPA command. IPM should
be issued even if there is no change in the subnet mask.
Changing the IP address will cause the telnet/socket connection to
break. So, the telnet/application should reconnect to the new IP
address after timeout.
For Reading also, IPA? is followed by IPM?
Command or Query.
Sets the IP Subnet mask for the interface IP address.
yy is the submet mask in bits [8..32]
See the NOTE above for IPA.
Command or Query.
Sets the one of four hdlc addresss, where:
In small network mode value is 0x01-0xFE
In large network value is 0x0001-0x7FFE
To delete, set the value to 0xFFFF.
Example:
<1/HAD[3]=AB will set the HDLC address to 0xAB
<1/HAD[2]=FFFF will Clear/Delete the HDLC Address.
In Point-to-Point or vipersat mode the values are not used.
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
IPA = IPA? IPA= xxx.xxx.xxx.xxx
IPA! (see description of
arguments)
IPM= IPM? IPM=yy
IPM!
HAD= HAD? HAD= xxxx
HAD! (see description of
arguments)
MN/CDM570L.AA4