Comtech EF Data CDM-570L Installation And Operation Manual page 55

Param File Tag
HDLC_ADDR_MODE
QOSC
QOSCDEFR
DIFFSSV#0 ... DIFFSSV#11
IGMP_QRYP
IGMP_MXRT
IGMP_MRP
IGMP_QUERIES
Page 15 of 54 51
Values Associated with Parameter
Small Network Mode
Large Network Mode
Point-To-Point Mode
If there are no QoS rules configured, (or) system is not in Max-Pri (or) Min-Max mode, then param file will not
have an entry for QOSC. Otherwise, the rules will be in the following format.
QOSC### = SrcIP/Mask
QOSC#1 = ***/*
QOSC#2 = 11.12.13.14/32
Where
spm – source port min; spM – source port Max;
mxB – Max bandwidth in kbps;
qos rules should be less than the Tx-Data rate of the system.]
P – Priority; W – WRED; F – Filter;
The default rule always exists in the system and in param file, but not meaningful if QoS mode is DiffServ. The
format is
QOSC### = SrcIP/Mask
QOSCDEFR#0 = ***/*
The DiffServ rules are meaningful only when QoS mode is DiffServ. Otherwise, these parameters can be
discarded. The format is as follows. The first column is
DIFFSSV#0 = 0 99999
NOTE: Donot use this from PARAM file, instead use DTG? Command.
A decimal value of
1...600
A decimal value of
1...598
A decimal value of
1...30
Possible string values are
Yes
No
DstIP/Mask PROT spm
***/* RTP *** ***
22.22.33.44/32 UDP 11111 22222 33333 44444 99999 0
dpm – Destination port min;
mb – minimum bandwidth in kbps [Total aggregate min bandwidth of all the
[Y – Yes, N – No]
DstIP/Mask PROT spm spM dpm dpM mxB
***/* ALL *** *** ***
spM dpm dpM mxB mb
*** *** 22222 0 4 N Y
dpM – Destination port Max
mb P W F
*** 99999 0 9 N N
MN/CDM570L.AA4
P W F
0 Y N