Comtech EF Data CDM-570L Installation And Operation Manual page 29

Command Arguments
Parameter (Instruction for Command
Type Code and or Response
Qualifier) to Query
Qos Rule QSR= QSR[0..32]=
Index-0 is the
default rule
25
Page 15 of 54
Description of Arguments
Command or Query.
QSR=tt|p|sss.sss.sss.sss/ss|ddd.ddd.ddd.ddd/dd|AAAAA|BBBBB|C
CCCC|DDDDD|mmmmm|MMMMM|w|f
Where t = Protocol Type:
01 - UDP 02 - TCP 03-ICMP
04-RTP 05-VOCE 06-VDEO
07-RTPS
08-FTP 09-HTTP 10-TELN 11-SMTP
12-SNMP 13-SAP 14-ORCL
15-CTRX 16-SQL 17-IP 18 for N-IP
19-ALL [Valid only for default rule]
Where p =
PRI=1..8 (only applies in max/priority mode). In Min/Max mode
priority for all rules is fixed at 8. User should not be alled to change
priority in Min/Max mode. Priority-9 is being used for default rule,
and obtained from PARAM file. Pri-9 cannot be used for
configuring other rules.
Where s = Source IP
SIP=xxx.xxx.xxx.xxx/yy [yy – subnet mask]. All '*' signifies all IP
address range[***.***.***.***/**].
Where d = Destination IP
DIP=xxx.xxx.xxx.xxx/yy [yy – subnet mask]. All '*' signifies all
IP address range, like [***.***.***.***/**]
All '*' signifies all port range of
00000 – 65535 for TCP/UDP. All port
numbers should in fixed length of 5-chars
Where A = TCP/UDP Source Port range
SPS=aaaaa [Source Port range Start]
Where B = [Source Port range Finish]
SPF=bbbbb
Where C = [Dest Port range Start]
DPS=ccccc
Where D = [Dest Port range Finish]
DPF=ddddd
Where m =
MINBW = mmmmm (meaningful in min.max mode). This is 0 in
Max Priority
mode. The number should be mentioned with preceding zeros, to
make it a fixed length of 5-chars.
Where M =
MXB=MMMMM (meaningful in max/pri and min./max modes
only). The number should be mentioned with preceding zeros, to
make it a fixed length of 5-chars.
W = WRED = 0-No 1-Yes
F = FILTER = 0-No 1-Yes
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
QSR = QSR[0..32]? QSR[0..32] =
QSR! Index-0 is the See description.
default rule Index-0 is the default
rule
MN/CDM570L.AA4