Comtech EF Data CDM-570L Installation And Operation Manual page 37

Arguments
Command
Parameter (Instruction
Command
Type Code and
or Response
Qualifier)
to Query
Reset Unit RST 1 byte value.
1 - reset the
system.
Restore RFD 1-Byte value
Factory 1 - restore
Defaults
Load Params LPS= 1-Byte value
from 1 – load
permanent parameters
storage
Codecast CCA= Multicast IP
Multicast Address in
Address xxx.xxx.xxx.
xxx format
Unit Up Time N/A String value
Page 15 of 54 33
for
Description of Arguments
Command only.
Setting the parameter to 1 resets the system. Telnet2 connection
needs to be re-established.
Command only.
Setting this to '1' will bring the modem back to factory defaults. This
may force unit reboot, depending on the mode of operation.
Command only.
Setting this to '1' loads the system with parameters from permanent
storage/flash. This may force unit reboot, depending on the mode of
operation.
Command or Query.
Set the Code cast multicast address, through which the modem can
receive the software updates via vLoad application. Only Multicast
address in the range 224.xxx.xxx.xxx To 239.xxx.xxx.xxx are
allowed. There are some reserved multicast addresses which cannot
be used.
This cannot be deleted.
Query only
Displays the unit up time in days, hours, minutes & seconds.
Example: >0001/uut=0 days 0 hours 13 mins 15 secs
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
RST= N/A RST=x
RST! (see description of
arguments)
RFD= N/A RFD=x
RFD! (see description of
arguments)
LPS= N/A LPS=x
LPS! (see description of
arguments)
CCA= CCA? CCA=xxx.xxx.xxx.xxx
CCA! (see description of
arguments)
N/A UUT? UUT=sssssss
String.
(see description of
arguments)
MN/CDM570L.AA4