Routing Engine Interface Cable And Wire Specifications For Mx Series; Routers - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Table 69: Estimated Values for Factors Causing Link Loss (continued)
Link-Loss Factor
Connector
Splice
Fiber attenuation
Related
Documentation
Routing Engine Interface Cable and Wire Specifications for MX Series Routers
142
Estimated Link-Loss Value
0.5 dB
0.5 dB
Single-mode—0.5 dB/km
Multimode—1 dB/km
The following sample calculation for a 2-km-long multimode link with a power budget
(P ) of 13 dB uses the estimated values from
B
(LL) as the sum of fiber attenuation (2 km @ 1 dB/km, or 2 dB) and loss for five connectors
(0.5 dB per connector, or 2.5 dB) and two splices (0.5 dB per splice, or 1 dB) as well as
higher-order mode losses (0.5 dB). The power margin (P
P = P – LL
M B
P = 13 dB – 2 km (1 dB/km) – 5 (0.5 dB) – 2 (0.5 dB) – 0.5 dB
M
P = 13 dB – 2 dB – 2.5 dB – 1 dB – 0.5 dB
M
P = 7 dB
M
The following sample calculation for an 8-km-long single-mode link with a power budget
(P ) of 13 dB uses the estimated values from
B
(LL) as the sum of fiber attenuation (8 km @ 0.5 dB/km, or 4 dB) and loss for seven
connectors (0.5 dB per connector, or 3.5 dB). The power margin (P
follows:
P = P – LL
M B
P = 13 dB – 8 km (0.5 dB/km) – 7(0.5 dB)
M
P = 13 dB – 4 dB – 3.5 dB
M
P = 5.5 dB
M
In both examples, the calculated power margin is greater than zero, indicating that the
link has sufficient power for transmission and does not exceed the maximum receiver
input power.
Understanding Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion on page 139
Table 70 on page 143 lists the specifications for the cables that connect to management
ports and the wires that connect to the alarm relay contacts.
Table 69 on page 141 to calculate link loss
) is calculated as follows:
M
Table 69 on page 141 to calculate link loss
) is calculated as
M
Copyright © 2017, Juniper Networks, Inc.