Installing A T640 Dc Power Supply Cable On A Two-Input 160-A Power Supply, Three-Input 240-A Dc Power Supply, Or A Four-Input 240-Adc Power Supply; Figure 201: Disconnecting A Dc Power Cable From A Four-Input 240-A Dc Power - Juniper T640 Hardware Manual

Copyright © 2013, Juniper Networks, Inc.
Figure 201: Disconnecting a DC Power Cable from a Four-Input 240-A DC
Power Supply
Cable lug
Locking
washer
Nut
Installing a T640 DC Power Supply Cable on a Two-Input 160-A Power Supply,
Three-Input 240-A DC Power Supply, or a Four-Input 240-A DC Power Supply
NOTE: All inputs on the two-input 160-A DC power supply in slot
be powered by dedicated power feeds derived from feed A, and all inputs on
the two-input 160-A DC power supply in slot
dedicated power feeds derived from feed B. This configuration provides the
commonly deployed A/B feed redundancy for the system.
NOTE: Only
INPUT 0
on the three-input 240-A DC power supply is not supported. Do not connect
2
the replacement cable to
240-A DC power supply in slot
feeds derived from feed A, and
DC power supply in slot
derived from feed B. This configuration provides the commonly deployed
A/B feed redundancy for the system.
Chapter 17: Replacing T640 Router Hardware Components
Terminal studs
and are supported for the T640 router.
INPUT 1
INPUT 2 . INPUT 0
must be powered by dedicated power
PEM0
and
INPUT 0 INPUT 1
PEM1 must be powered by dedicated power feeds
PEM0
PEM1 must be powered by
INPUT
and INPUT 1 on the three-input
on the three-input 240-A
must
337