Installing A T4000-Sib; Figure 134: Removing A T4000 Sib - Juniper T4000 Hardware Manual

T4000 Router Hardware Guide

Installing a T4000-SIB

280
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
5.
way out of the chassis.
Place one hand underneath the SIB to support it, and slide it completely out of the
6.
chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.

Figure 134: Removing a T4000 SIB

To install a T4000-SIB (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles, and press them inward to seat the SIB. Ensure that the
5.
ejector handle tabs are properly mated inside their corresponding chassis slots. You
might have to close and open the handles a few times before the tabs catch the slots.
Figure 135 on page 282):
Copyright © 2013, Juniper Networks, Inc.