Installing A T320 Sib; Figure 92: Removing A T320 Sib - Juniper T320 Hardware Manual

Installing a T320 SIB

Copyright © 2010, Juniper Networks, Inc.
Press the online/offline button on the SIB faceplate. Press and hold down the button
3.
until the green LED goes out (about 5 seconds).
OK
Loosen the captive screws (using a Phillips (+) screwdriver, number 2) on the ejector
4.
handles on each side of the SIB faceplate.
Flip the ejector handles outward to unseat the SIB.
5.
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
6.
way out of the chassis.
Place one hand underneath the SIB to support it and slide it completely out of the
7.
chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.

Figure 92: Removing a T320 SIB

To install a SIB into the rear of the chassis (see Figure 93 on page 176):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "Preventing Electrostatic Discharge Damage to a T320 Router" on page 210.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB faceplate.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Chapter 14: Replacing the T320 Router Hardware Components
175