Tools and Parts Required for Replacing T4000 Hardware Components
Copyright © 2013, Juniper Networks, Inc.
To replace hardware components, you need the tools and parts listed in
Table 41 on page
217.
Table 41: Tools and Parts Required for Component Replacement
Components
All
Air filter (front or rear)
CIP
Craft interface
Control board
DC power supply
DC power supply cable
Fan tray (front or rear)
FPC
Chapter 19: Replacing T4000 Router Hardware Components
Tool or part
Electrostatic discharge (ESD) grounding wrist
strap
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) nut driver
CAUTION:
You must use an appropriate
torque-controlled tool to tighten the nuts.
Applying excessive torque damages the
terminal studs and the power supply. The
absolute maximum torque that may be applied
to this nut is 45 in-lb (5.0 Nm).
7/16-in. (11 mm) nut driver
CAUTION:
You must use an appropriate
torque-controlled tool to tighten the nuts.
Applying excessive torque damages the
terminal studs and the power supply. The
absolute maximum torque that may be applied
to this nut is 45 in-lb (5.0 Nm).
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Blank panel (if component is not reinstalled)
Electrostatic bag or antistatic mat
217