Configuring User Access And Authentication; Configuring Radius Authentication (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

CHAPTER 1
Configuring User Access and
Authentication

Configuring RADIUS Authentication (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
This section contains the following:
Configuring RADIUS Authentication (NSM Procedure) on page 3
Configuring TACACS+ Authentication (NSM Procedure) on page 4
Configuring Authentication Order (NSM Procedure) on page 5
Configuring User Access (NSM Procedure) on page 6
Configuring Template Accounts (NSM Procedure) on page 7
To use RADIUS authentication, you must configure at least one RADIUS server. Configuring
RADIUS authentication involves identifying the RADIUS server, specifying the secret
(password) of the RADIUS server, and setting the source address of the device's RADIUS
requests to the loopback address of the device.
To configure RADIUS authentication:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure RADIUS authentication.
Click the Configuration tab. In the configuration tree, select System > Radius Server.
3.
Add or modify Radius settings as specified in Table 5 on page 4.
4.
Click one:
5.
New—Adds a new RADIUS server.
OK—Saves the changes.
Cancel—Cancels the modifications.
3