Monitoring Global Call Admission Control Configuration; Accounting - Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual

Related Topics

Monitoring Global Call Admission Control Configuration

Purpose
Action
Related Topics
Monitoring Interfaces Configured with Traffic Engineering Bandwidth Accounting
Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
Table 60: show atm vc Output Fields (continued)
Field Name
Encap
Category
Rx/Tx Peak
Rx/Tx Avg
Rx/Tx Burst
Status
Start VPI
Start VCI
End VPI
End VCI
show atm vc
Display global call admission control (CAC) configuration.
To display CAC configuration:
host1#show cac
resource info flood interval 180
show cac
Display interfaces on which traffic engineering bandwidth accounting is configured.
To display information about CAC interfaces:
host1#show cac interface
atm2/0
bandwidth 10 kbps
IP/MPLS reserveable bw 10 kbps
current total available bw 10 kbps
MPLS TE flooding threshold:
up 15 30 45 60 75 80 85 90 95 96 97 98 99 100
down 100 99 98 97 96 95 90 85 80 75 60 45 30 15
Field Description
Encapsulation method: AUTO, AAL5, MUX, SNAP, ILMI, F4-OAM
Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, CBR
Peak rate in Kbps
Average rate in Kbps
Maximum number of cells that can be burst at the peak cell rate
State of the virtual circuit: Up, Down
Starting virtual path identifier (inclusive) of the reserved VC range
Starting virtual circuit identifier (inclusive) of the reserved VC range
Ending virtual path identifier (inclusive) of the reserved VC range
Ending virtual circuit identifier (inclusive) of the reserved VC range
Chapter 5: Monitoring MPLS
327