Background Operations; Time-Out Timer (Tot); Battery Saver; Low Battery Warning - Kenwood ProTalk DIGITAL TK-3701D User Manual

TIME-OUT TIMER (TOT)

The Time-out Timer prevent callers from using a channel for an extended duration.
If you continuously transmit for the duration programmed by your dealer (default is
60 seconds), transmission will stop and an alert tone will sound. To stop the tone,
release the PTT switch.

BATTERY SAVER

When activated by your dealer, the Battery Saver function decreases the amount
of power used after no signal is present and no operations are being performed
for specific time periods. When a signal is received or an operation is performed,
Battery Saver turns off.
Note:
◆ The timing of starting Battery Saver is different between Analogue and Digital Mode.
◆ While the Battery Saver is operating, the LED may flash green when receiving a QT/
DQT/Common ID signal which does not match the QT/DQT/Common ID set up in your
transceiver.

LOW BATTERY WARNING

While operating the transceiver, the Low Battery Warning sounds an alert tone
every 30 seconds and the LED indicator blinks red when the battery needs
recharged or replaced.

BUSY CHANNEL LOCKOUT (BCL)

When activated by your dealer, BCL prevents you from interfering on a channel that
is already in use. Pressing the PTT switch will cause a warning tone to sound and
the transceiver will not transmit. Release the PTT switch to stop the tone.
Note:
◆ The transceiver transmits according to the configuration in Busy Channel Lockout by
your dealer.

VOICE ANNOUNCEMENT

An audio voice will be announced as below by dealer setting.
• When changing the zone and/or channel, the new zone and channel number are
announced.
• When changing the function on/ off, the new setting is announced.
- Scrambler
- Button lock
- Scan

BACKGROUND OPERATIONS

27