Figure 58: Logging In For Programming Access - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-882 Media Redundancy ETHERNET Controller
Log in with the administrator password to program the fieldbus controller!
If you have activated password protection for port 2455 on the "Security" page of
the WBM, you have to log into WAGO-I/O-PRO in the menu Online > Log In to
obtain programming access to the fieldbus controller (default password "wago").

Figure 58: Logging in for Programming Access

9. Under Online, click the menu item Login to log in to the fieldbus controller
The WAGO-I/O-PRO Server is active during online operation. The
communication parameters can not be called up during this time.
Depending on whether a program is already present in the fieldbus controller, a
window will appear asking whether a (new) program should be loaded.
10. Respond with Yes to load the current program.
11. In menu Online, click on Create Boot project.
You compiled project will also be executed by this method, if you restart the
fieldbus controller or if there is a power failure.
12. Once the program has been loaded, start program processing in the menu
Online, menu item Start.
This command starts the processing of your program in the control system or in
the simulation.
"ONLINE" and "RUNNING" will then appear at the right of the status bar.
13. To terminate online operation, click the menu item Log off in the menu
Online.
Programming the PFC Using WAGO-I/O-PRO 147
Manual
1.5.0