Tcp/Ip - WAGO -I/O-SYSTEM 750 Manual

158 Configuring via the Web-Based Management System (WBM) WAGO-I/O-SYSTEM 750
10.3

TCP/IP

You can configure network addressing and network identification on the "TCP/IP"
WBM page.
Set the DIP switch to "0" and enable "use IP from EEPROM"!
Before you change parameters on this page, set the DIP switch to zero and on
the "Port" WBM page, set the "use IP from EEPROM" option!
If these conditions are not met, the DIP switch settings are applied instead.
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller