Figure 10: Removing The Fuse Carrier; Figure 11: Opening The Fuse Carrier; Figure 12: Changing The Fuse - WAGO -I/O-SYSTEM 750 Manual

36 System Description
In order to insert or change a fuse, or to switch off the voltage in succeeding I/O
modules, the fuse holder may be pulled out. In order to do this, use a screwdriver
for example, to reach into one of the slits (one on both sides) and pull out the
holder.

Figure 10: Removing the Fuse Carrier

Lifting the cover to the side opens the fuse carrier.

Figure 11: Opening the Fuse Carrier

Figure 12: Changing the Fuse

After changing the fuse, the fuse carrier is pushed back into its original position.
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
WAGO-I/O-SYSTEM 750