Shielded Signal Lines; Wago Shield Connecting System; Figure 21: Examples Of The Wago Shield Connecting System; Figure 22: Application Of The Wago Shield Connecting System - WAGO -I/O-SYSTEM 750 Manual
Hide thumbs
Also See for WAGO-I/O-SYSTEM 750:
- User's installation and configuration (335 pages) ,
- Technical description, installation and configuration (236 pages) ,
- Manual (228 pages)
Table of Contents
Advertisement
46
System Description
3.8.3
Shielded Signal Lines
Use shielded signal lines!
Always use shielded signal lines for analog signals and I/O modules which are
equipped with shield clamps. Only then you can ensure that the accuracy and
interference immunity specified for the respective I/O module can be achieved
even in the presence of interference acting on the signal cable.
On some WAGO devices you can directly clamp the shield. For all other devices
use the WAGO shield connecting system.
3.8.4
WAGO Shield Connecting System
The series 790 WAGO shield connecting system consists of shield clamping
saddles, busbars and various mounting carriers. These components can be used
to achieve many different configurations.
Figure 21: Examples of the WAGO Shield Connecting System
Figure 22: Application of the WAGO Shield Connecting System
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
WAGO-I/O-SYSTEM 750
Advertisement
Chapters
Table of Contents
