Table 222: Ethernet Link - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-882 Media Redundancy ETHERNET Controller
Instance 1
Table 222: Ethernet link (F6
Attribute ID
1
2
3
6
7
8
) – Instance 1
hex
Acces Name
s
Get Interface Speed
Get Interface Flags
Get Physical Address ARRAY of
Set Interface Control
Control Bits
Forced Interface
Speed
Get Interface Type
Get Interface Status
Fieldbus Communication 285
Data type Description
UDINT Transfer rate
DWORD Interface configuration
and status information
Bit 0: Link status
Bit 1: Half/full duplex
Bit 2...4: Detection
status
Bit 5: Manual settings
require reset
Bit 6: Local hardware
error
Bit 7...31: Reserved
MAC layer address
6 UINTs
STRUCT Configuration of the
of: physical interface
WORD Interface configuration
bits
Bit 0: Automatic
detection
Bit 1: Default duplex
mode
Bit 2...15: Reserved
UINT Preset interface speed 10 (0x000A) or
USINT Interface type
Value 0: Unknown
Value 1: Internal
interface; e.g., in the
case of an integrated
switch
Value 2: Twisted pair
(e.g. 100Base-TX).
Value 3: fiber glass
(e.g. 100Base-FX).
Value 4...256:
Reserved
USINT Interface status
Value 0: Unknown
Value 1: Interface
active and ready to
send/receive.
Value 2: Interface
deactivated.
Value 3: Interface is
testing
Wert 4...256:
Reserved
Default value
10 (0x0A) or
100 (0x64)
Value is dependent
upon Ethernet
connection.
MAC ID of the device
-
0x0001
100 (0x0064)
2 (0x02) – Twisted
Pair
-
Manual
1.5.0