10.14 Features; Figure 73: Wbm Page "Features; Table 53: Wbm Page "Features - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750 Configuring via the Web-Based Management System (WBM) 187
750-882 Media Redundancy ETHERNET Controller

10.14 Features

Use the "Features" WBM page to enable or disable additional functions.

Figure 73: WBM Page "Features"

Table 53: WBM Page "Features"

Additional Functions
Entry
Autoreset on
system error
BootP Request
before Static-IP
Non-adaptive Kbus
speed active
Default Description
Enables an automatic software reset to be conducted

when a system error occurs

Disables an automatic software reset to be conducted

when a system error occurs
Automatically set the static IP address enabled.
For this configuration, the fieldbus coupler/

controller uses a statically configured IP address if the
request via BootP fails.

Automatically set the static IP address disabled.
 For this configuration, the IP address request via BootP
is repeated in the event of error.
Disable the rate adjustment of the local bus for short
fieldbus nodes. With short fieldbus nodes, doing so

makes more computing power available for the PLC

application. The local bus rate is correspondingly
lower.
Enables the rate adjustment of the local bus.

Manual
1.5.0