Security - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750 Configuring via the Web-Based Management System (WBM) 175
750-882 Media Redundancy ETHERNET Controller
10.9

Security

Use the "Security" WBM page with passwords to set up read and/or write access
for various user groups to protect against configuration changes.
Changing the passwords requires administrator rights and software reset!
You can only change the passwords as an administrator with the user rights
"admin" and the associated password.
Press the [Software Reset] button to restart the software for the setting changes
to take effect.
Note password restrictions!
The following restriction is applied for passwords:
• Max. 32 characters inclusive special characters.
Renew access after software reset!
If you initiate a software reset on this page, then the fieldbus coupler/controller
starts with the configurations previously loaded into the EEPROM and the
connection to the browser is interrupted.
If you changed the IP address previously, you have to use the changed IP
address to access the device from the browser.
You have not changed the IP address and performed other settings; you can
restore the connection by refreshing the browser.
Manual
1.5.0