Channel Digital Output Modules; Channel Digital Output Modules With Diagnostics And Input Process Data; Table 430: 2 Channel Digital Input Modules With Diagnostics And Input Process; Table 431: 4 Channel Digital Output Modules - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-882 Media Redundancy ETHERNET Controller
Table 430: 2 Channel Digital Input Modules with Diagnostics and Input Process Data 75x-506
Input Process Image
Bit 7
Diagnostic bits S1/S0, S3/S2: = '00'
Diagnostic bits S1/S0, S3/S2: = '01'
Diagnostic bits S1/S0, S3/S2: = '10'
The output modules seize 4 Instances in Class (0x65).
Output Process Image
Bit 7
And the output modules seize 4 Instances in Class (0x66).
13.3.2.4

4 Channel Digital Output Modules

750-504, -516, -519, -531,
753-504, -516, -531, -540

Table 431: 4 Channel Digital Output Modules

Output Process Image
Bit 7
The output modules seize 4 Instances in Class (0x66).
13.3.2.5 4 Channel Digital Output Modules with Diagnostics and Input
Process Data
750-532
The digital output modules have a diagnostic bit for each output channel. When
an output fault condition occurs (i.e., overload, short circuit, or broken wire), a
diagnostic bit is set. The diagnostic data is mapped into the Input Process Image,
while the output control bits are in the Output Process Image.
Table 432: 4 Channel Digital Output Modules with Diagnostics and Input Process Data
Input Process Image
Bit 7
Diagnostic bit S = '0'
Diagnostic bit S = '1'
The output modules seize 4 Instances in Class (0x65).
Bit 6 Bit 5 Bit 4
Bit 6 Bit 5 Bit 4
Bit 6 Bit 5 Bit 4
Bit 6 Bit 5 Bit 4
no Error
overload, short circuit, or broken wire
Bit 3 Bit 2
Diagnostic bit Diagnostic bit
S 3 S 2
Channel 2 Channel 2
standard mode
no connected load/short circuit against +24 V
Short circuit to ground/overload
Bit 3 Bit 2
not used not used
Bit 3 Bit 2
controls controls
DO 4 DO 3
Channel 4 Channel 3
Bit 3 Bit 2
Diagnostic Diagnostic
bit bit
S 4 S 3
Channel 4 Channel 3
I/O Modules 375
Bit 1 Bit 0
Diagnostic Diagnostic bit
bit S 1 S 0
Channel 1 Channel 1
Bit 1 Bit 0
controls controls
DO 2 DO 1
Channel 2 Channel 1
Bit 1 Bit 0
controls controls
DO 2 DO 1
Channel 2 Channel 1
Bit 1 Bit 0
Diagnostic
Diagnostic bit
bit
S 1
S 2
Channel 1
Channel 2
Manual
1.5.0