Table 163: Register Address 0X2033; Table 164: Register Address 0X2040; Table 165: Register Address 0X2041; Table 166: Register Address 0X2042 - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-882 Media Redundancy ETHERNET Controller

Table 163: Register Address 0x2033

Register address 0x2033 (8243
Value
Access
Description

Table 164: Register Address 0x2040

Register address 0x2040 (8256
Value
Access
Description

Table 165: Register Address 0x2041

Register address 0x2041 (8257
Value
Access
Description

Table 166: Register Address 0x2042

Register address 0x2042 (8258
Value
Access
Description

Table 167: Register Address 0x2043

Register address 0x2043 (8259
Value
Access
Description
) with a word count of up to 65
dec
Description of the connected I/O modules
Read modules 193 ... 255
Length 1...63 words
The node configuration can be specified in the 0x2033 register. The item number
of the I/O modules or fieldbus coupler/controller (without leading 750) is listed in
order. Because order numbers cannot be read out of digital modules, a code is
displayed for them, as defined below:
Bit position 0
Bit position 1
Bit position 2...7
Bit position 8...14 
Bit position 15
)
dec
Implement a software reset
Write (Write sequence 0xAA55 or 0x55AA)
The fieldbus coupler/controller performs a restart by writing the values 0xAA55 or
0x55AA.
)
dez
Flash format
Write (Write sequence 0xAA55 or 0x55AA)
The file system Flash is again formatted.
)
dez
Extract data files
Write (Write sequence 0xAA55 or 0x55AA)
The standard files (HTML pages) of the Coupler/Controller are extracted and
written into the Flash.
)
dez
0x55AA
Write
Factory settings
The default settings are applied after the next reset, e.g., software reset via
MODBUS register address 0x2040.
Fieldbus Communication 259
Input module

Output module

Not used

Module size in bits
Designation digital module

Manual
1.5.0