WAGO -I/O-SYSTEM 750 Manual page 112

112 Commissioning
IP address assignment is not possible via the router!
The IP address is assigned via patch cable, switches, hubs, or via direct link
using a crossover cable. Addresses cannot be assigned via routers.
BootP must be enabled on the Web pages!
Note that BootP must be enabled on the internal Web pages of the WBM, HTML
page "Port configuration".
BootP is enabled by default when delivered.
Additional Information
Assigning IP addresses using a BootP server can be carried out in any Windows
and Linux operating system. Any other BootP servers may also be used, besides
the WAGO-BootP server.
More information about the WAGO-BootP-Server
The "WAGO-BootP-Server 759-315" is available free of charge at
http://www.wago.com.
The following steps are included:
• Note MAC IDs
• Note IP addresses
• Assigning the IP addresses and enable BootP
• Assigning the IP addresses permanently by option "use IP from EEPROM"
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
WAGO-I/O-SYSTEM 750