Table 43: Wbm Page "Port - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750 Configuring via the Web-Based Management System (WBM) 163
750-882 Media Redundancy ETHERNET Controller

Table 43: WBM page "Port"

Port Settings Eth1/Eth2
Entry
FTP (Port 21)
SNTP (Port 123)
HTTP (Port 80)
HTTPS (Port 443)
SNMP (Port 161, 162)
Ethernet IP (TCP-Port 44818,
Modbus UDP (Port 502)
Modbus TCP (Port 502)
WAGO Services (Port 6626)
CODESYS (Port 2455)
Boot Options Eth1/Eth2
BootP (Port 68)
DHCP (Port 68)
use IP from EEPROM
)
* Both ETHERNET ports must be set equally, only either EtherNet/IP or MODBUS (UDP, TCP)
must be enabled so that fieldbus process data exchange is possible.
Entry
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
UDP-Port 2222)
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Entry
activating "File Transfer Protocol"


deactivating "File Transfer Protocol"

activating "Simple Network Time Protocol"


deactivating "Simple Network Time Protocol"

activating "Hypertext Transfer Protocol"


deactivating "Hypertext Transfer Protocol"

activating "Hypertext Transfer Protocol over

SSL-encrypted connection"

deactivating "Hypertext Transfer Protocol

over SSL-encrypted connection"
Operate WebVisu via HTTPS!
You can operate WebVisu via HTTPS protocol,
provided HTTPS is activated and you use a
WAGO-I/O-PRO version >= .42.
activating "Simple Network Management

Protocol"

deactivating "Simple Network Management

Protocol"
activating EtherNet/IP protocol

)
 *
deactivating EtherNet/IP protocol

activating MODBUS/UDP protocol

)
 *
deactivating MODBUS/UDP protocol

activating MODBUS/TCP protocol

)
 *
deactivating MODBUS/TCP protocol

activating WAGO services


de activating WAGO services

activating WAGO-I/O-PRO (CODESYS)


deactivating WAGO-I/O-PRO (CODESYS)

activating "Bootstrap Protocol"


deactivating "Bootstrap Protocol"

activating "Dynamic Host Configuration

Protocol"

deactivating "Dynamic Host Configuration

Protocol"
activating use of IP address from EEPROM


deactivating use of IP address from

EEPROM
Manual
1.5.0