WAGO -I/O-SYSTEM 750 Manual page 133

WAGO-I/O-SYSTEM 750
750-882 Media Redundancy ETHERNET Controller
5. Then complete the fourth line for each individual module using this syntax
and set the corresponding assigned access privileges.
The number of line entries must correspond with the number of bus
terminals used!
It is imperative that the number of line entries concurs with the number of existing
hardware modules.
6. Save the file and reload it to the controller file system via FTP client.
You can then begin with IEC-61131-3 programming.
Additional Information:
For a detailed description of how to use the software, refer to the WAGO-I/O-
PRO manual. The manual is available in the Internet under:
http://www.wago.com
 759-333
Programming the PFC Using WAGO-I/O-PRO 133
 Documentation  WAGO Software  WAGO-I/O-PRO
Manual
1.5.0