Figure 31: Dialog Window Dtm Parameters - WAGO I/O-SYSTEM 750 Manual

80 Commissioning

Figure 31: Dialog Window DTM Parameters

16. Select the desired module from the left side of the tree structure; the
displayed module number corresponds to the slot in the structure – module
01 is the bus coupler.
The right side contains the parameterization dialog for this module.
17. Set the desired parameter for each channel separately, such as
•
•
•
When the simulation is activated, the selected simulation value is output as
a process value. When selecting an overflow or underflow, the overflow or
underflow is overlaid (last 2 bits), as output in the status byte.
Manual
Version 1.4.0
the analog Filter time for the input channel (10 ms ... 640 ms),
the Simulation mode activation, and
the Simulation value setting with the Over range or Under range
selection.
WAGO-I/O-SYSTEM 750
750-484 2AI 4-20mA HART Ex i