Assigning The Ip Address; Assigning The Ip Address Permanently By Option "Use Ip From Eeprom - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-882 Media Redundancy ETHERNET Controller
Assign the PC a fixed IP address and note common subnet!
Note that the PC, on which the BootP server is listed, must have a fixed IP
address and that the fieldbus node and PC must be in the same subnet.
6. Note the IP address you have selected:
Fieldbus node IP address:
8.2.5.3

Assigning the IP address

1. Based on the handling, which depends on the BootP program set, assign
the required IP address for your fieldbus node.
2. Enable the query/response mechanism of the BootP protocol based on the
handling, which depends on the BootP program set. Alternatively, do the
activation of BootP in "WAGO Ethernet Settings" or if an access to the
internal Web pages of WBM is already possible via an IP address, in the
Web-based management system.
3. To apply the new IP address, use e.g. a hardware reset to restart your
fieldbus node by interrupt the voltage supply for approx. 2 seconds.
8.2.5.4 Assigning the IP address permanently by option "use IP from
EEPROM"
When the BootP protocol is activated the fieldbus controller expects the BootP
server to be permanently available. If there is no BootP server available after a
PowerOn reset, the network will remain inactive.
IP stored in EEPROM must be used to assign the address permanently!
To apply the new IP address permanently in the fieldbus controller, the option
"use IP from EEPROM" must be selected. Thus, the IP address is automatically
entered as static address and used in the EEPROM.
You can enable the option "use IP from EEPROM" in the Web-based
Management System.
1. Open the Web browser on your client (such as the Microsoft Internet
Explorer) to have the HTML pages displayed.
2. Enter the IP address for your fieldbus node in the address line of the
browser and press [Return].
Commissioning 115
_ _ _ . _ _ _ . _ _ _ . _ _ _
Manual
1.5.0