WAGO -I/O-SYSTEM 750 Manual page 109

WAGO-I/O-SYSTEM 750
750-882 Media Redundancy ETHERNET Controller
2. Enter the IP address for your fieldbus node in the address line of the
browser and press [Return].
3. If a dialog window then appears with a password prompt, as Administrator,
enter the user name: "admin" and the password "wago".
This is provided for secure access and entails three different user groups:
admin, guest and user.
A start page is then displayed in the browser window with information about
your fieldbus controller (start page can be changed on HTML page
"Security").
You can navigate to the respective configuration pages using the hyperlinks
in the left navigation bar.
In the left navigation bar click on Port to open the HTML page for selecting
4.
a protocol.
You are shown a list of all the protocols supported by the fieldbus controller.
5. Select the option "use IP from EEPROM".
At the same time disables the use of DHCP server.
6. Confirm your changes with button [SUBMIT].
7. Then restart in order for the settings to take effect.
8. For a restart, click in the left navigation bar on the link [Security] to open
the HTML page on which you can set passwords and trigger a software
reset.
9. Click on the button [Software Reset] at the bottom of the page.
Then the coupler/controller starts with the configurations, which were
previously loaded into the EEPROM and the connection to the browser is
interrupted.
10. Now you must use the changed IP address, if you want to access again on
this device via browser.
Commissioning 109
Manual
1.5.0