Figure 46: Address Selection Switch, For Example The Value Setting "50 - WAGO -I/O-SYSTEM 750 Manual

106 Commissioning
More information about changing the static base address
You can also change the base address currently saved in the fieldbus controller
as required.
Either proceed as described in the following section "Assigning IP Address via
Web Server".
1. To configure the IP address via the address selection switch by setting the
host ID (last position of the IP address) to a value that does not equal
0/255, first convert the host ID to the binary representation.
For example, host ID 50 results in a binary code of 00110010.
2. Set the bits in sequence using the 8 address switches. Start with address
switch 1 to set bit 0 (LSB) and end with address switch 8 for bit 7 (MSB).

Figure 46: Address Selection Switch, for Example the Value Setting "50" (2

3. Restart the fieldbus coupler after adjusting the address selection switch to
apply the configuration changes.
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
WAGO-I/O-SYSTEM 750
1 4 5
+ 2 + 2 )