Programming The Pfc Using Wago-I/O-Pro; Figure 50: Logging In For Programming Access - WAGO -I/O-SYSTEM 750 Manual

126 Programming the PFC Using WAGO-I/O-PRO

9 Programming the PFC Using WAGO-I/O-PRO
Using IEC 61131-3 programming, the Media Redundancy ETHERNET Controller
750-882 can also utilize the function of a PLC in addition to the functions of a
fieldbus coupler. Creation of an application program in line with IEC 61131-3 is
performed using the programming tool WAGO-I/O-PRO.
Compatibility with IEC-61131-3 programming software!
The compatibility between your fieldbus controller and the IEC 61131-3
programming software used depends on the fieldbus controller's firmware
version and the version of the programming software.
A list of recommended combinations can be found at www.wago.com.
Use the search function (search for "Compatibility Notes").
Activate option "CODESYS" in the web-based Management System for
programming!
Pay attention, the IEC 61131-3 programming of the controller via ETHERNET
requires that the check box CODESYS be activated at the Website "Port
Configuration" (default).
You can, however, also connect the client PC and controller serially for
programming using a programming cable.
Log in with the administrator password to program the fieldbus controller!
If you have activated password protection for port 2455 on the "Security" page of
the WBM, you have to log into WAGO-I/O-PRO in the menu Online > Log In to
obtain programming access to the fieldbus controller (default password "wago").

Figure 50: Logging in for Programming Access

Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
WAGO-I/O-SYSTEM 750