Table 54: Wbm Page "I/O Config - WAGO -I/O-SYSTEM 750 Manual

190 Configuring via the Web-Based Management System (WBM) WAGO-I/O-SYSTEM 750
Additional Information
For more detailed information about the WAGO-I/O-PRO I/O Configurator, refer
to the Section "Startup of Fieldbus Node".
When the function "I/O configuration Insert monitoring entries into ea-config.xml"
is also activated at the Web site "PLC", the current process values will also be
shown for the data channels that are displayed.

Table 54: WBM Page "I/O Config"

Configuration details
Entry
Number of modules on terminal bus 5
Number of modules in I/O
configuration
[create ea-config.xml]
I/O Configuration File
Entry
Pos
Module
Type
Mapping
Enter I/O modules in the I/O Configurator!
Enter the I/O modules used in the I/O configurator of WAGO-I/O-PRO. Here,
open the Control Configuration in the Resources register and add your I/O
modules to the I/O module figure.
The added I/O modules must match the hardware in sequence and quantity. The
entries "Number of modules on terminal bus" and "Number of modules in I/O
configuration" on the html page "I/O Config" serve as control.
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
Value (Example) Description
5
-
Value (Example) Description
1 Position of the I/O module in the hardware
750-4xx Product number of the integrated I/O module
M001Ch1
M001Ch2
2DI I/O module type, e.g. 2 DI (2 Channel Digital Input Module)
Fieldbus 3 Mapping via PLC, fieldbus 1 etc. (Entries depend on the
coupler/controller, see WAGO-I/O-PRO under control
parameters/module parameters)
Number of I/O modules (hardware)
Number of I/O modules in the hardware
configuration of the I/O
Writes the current bus terminal structure
and the field bus assignment in the „ea-
config.xml" file.
M = module, 001 = position 1, Ch1 = channel 1
M = module, 002 = position 2, Ch2 = channel 2