Address Selection Switch; Figure 29: Address Selection Switch (For Example Setting "0"); Table 20: Meaning Of Dip Switch Positions - WAGO -I/O-SYSTEM 750 Manual

58 Device Description
4.4.3

Address Selection Switch

Figure 29: Address Selection Switch (for example setting "0")

The 8-pole DIP switch is used to set the IP address and to select the protocol for
setting the IP address.

Table 20: Meaning of DIP switch positions

Address
0
1-254
255
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
Meaning
The IP parameter is configured via the web-based management.
BootP, DHCP and application of the values from the EEPROM
are available to the user. In the default status, configuration via
BootP is activated.
The configuration of the IP address consists of the network
address and the value set for the DIP switch.
The network address is configurable and 192.168.1 for Port 1
and 192.168.2 for Port 2 by default.
The DHCP protocol is used to configure the IP parameters.
WAGO-I/O-SYSTEM 750