Expansion Bus-F2/ IPSec Board-B2/ Wireless LAN
Board-B2
Points to Note at Installation
CAUTION:
• "PCI Bus Expansion Kit-F2" is required to set "IPSec Board-B2" and "Wireless LAN
Board-B2"
• When this equipment is used with "Serial Interface Kit-K1" or "Copy Control
Interface Kit-A1", install "Serial Interface Kit-K1" or "Copy Control Interface Kit-A1"
beforehand.
The following "Removing Main Controller PCB 1", there are 3 procedures based on the
installation combination.
Combination
Expansion
IPSec
Wireless
pattern
Bus-F2
Security
Board-B2
Board-B2
1
○
○
2
○
-
3
○
○
9
Installation > Expansion Bus-F2/ IPSec Board-B2/ Wireless LAN Board-B2 > Checking the contents [Expansion Bus-F2]
Reference for installation
LAN
Be sure to refer to "To install Expansion
Bus-F2 and IPSec Board-B2 at the same
-
time"
Be sure to refer to "To install Expansion
Bus-F2 and Wireless LAN Board-B2 and
○
IPSec Board-B2 at the same time".
Be sure to refer to "To install Expansion
Bus-F2 and Wireless LAN Board-B2 and
○
IPSec Board-B2 at the same time".
9
Installation > Expansion Bus-F2/ IPSec Board-B2/ Wireless LAN Board-B2 > Checking the contents [Expansion Bus-F2]
Checking the contents [Expansion Bus-F2]
[1] PCI Bus Expansion PCB X 1
[3] PCB Spacer X 3
[5] Riser Support Plate X 1
T-9-5
9-32
[2]
PCI Riser Support Plate
X 1
[4] Screw (TP; M3x6) X 5
F-9-64
9-32