4
Parts Replacement and Cleaning > Disassembly/Assembly- Main Controller system - > Removing the Controller Box
2) Remove the DC Controller PCB.
• 6 Screws
x6
After replacement:
Turn ON the power and execute the following service mode to restore DC Controller
PCB SRAM.
COPIER > FUNCTION > SYSTEM > DSRAMRES (LEVEL2)
"ACTIVE" is displayed at execution and then "OK!" is displayed about 2 minutes later.
Restoration is complete.
4
Parts Replacement and Cleaning > Disassembly/Assembly- Main Controller system - > Removing the Controller Box
Removing the Controller Box
Preparation
1) Remove the Rear Upper Cover.
2) Remove the Right Upper Sub Cover.
3) Remove the Controller Cover.
Procedure
1) Remove the 5 Connectors, 3 Flat Cables and 2 Wire Saddles.
• Wire Saddle
• Edge Saddle
F-4-34
2) Remove the Harness.
• Wire Saddle
x10
F-4-36
4-41
F-4-35
4-41