Canon imageRUNNER ADVANCE C2030 Service Manual page 535

E Detail Location Item
Code Code
E614 1102 00 Title Error in file system on the Flash PCB
Description The file system failed to be initialized properly at startup
Remedy 1. Turn OFF and then ON the main power
2. Start in safe mode and format the Flash PCB, and then
reinstall the system using SST or USB.
3. Replace the Flash PCB and install the system using SST or
USB
4. Replace Main Controller PCB 1
E614 1103 00 Title Error in file system on the Flash PCB
Description I/O error occurred in the file system at startup
Remedy 1. Turn OFF and then ON the main power
2. Start in safe mode and format the Flash PCB, and then
reinstall the system using SST or USB.
3. Replace the Flash PCB and install the system using SST or
USB
4. Replace Main Controller PCB 1
E614 1112 00 Title Error in file system on the Flash PCB
Description The file system failed to be initialized properly at startup
Remedy 1. Turn OFF and then ON the main power
2. Start in safe mode and format the Flash PCB, and then
reinstall the system using SST or USB.
3. Replace the Flash PCB and install the system using SST or
USB
4. Replace Main Controller PCB 1
E614 1113 00 Title Error in file system on the Flash PCB
Description Error in file system writing after startup
Remedy 1. Turn OFF and then ON the main power
2. Start in safe mode and format the Flash PCB, and then
reinstall the system using SST or USB.
3. Replace the Flash PCB and install the system using SST or
USB
4. Replace Main Controller PCB 1
7
Error Code > Error Code > Error Code Details
Description
7 Error Code > Error Code > Error Code Details
E Detail Location Item
Code Code
E614 1202 00 Title Error in file system on the Flash PCB
Description The file system failed to be initialized properly at startup
Remedy 1. Turn OFF and then ON the main power
2. Initialize the corresponding partition (all the data in the
corresponding partition is erased)
Select the following to enter 2: [1]:CHK-TYPE = 2, and execute
the following: [3]:HD-CLEAR = 1, and then turn OFF and ON
the power.
3. Erase all partitions that can be initialized (all of erasable
partition data is erased)
Select the following to enter 0: [1]:CHK-TYPE = 0, and execute
the following: [3]:HD-CLEAR = 1, and then turn OFF and ON
the power.
4. Start in safe mode and format the Flash PCB, and then
reinstall the system using SST or USB.
5. Replace the Flash PCB and install the system using SST or
USB
6. Replace Main Controller PCB 1
E614 1203 00 Title Error in file system on the Flash PCB
Description I/O error occurred in the file system at startup
Remedy 1. Turn OFF and then ON the main power
2. Initialize the corresponding partition (all the data in the
corresponding partition is erased)
Select the following to enter 2: [1]:CHK-TYPE = 2, and execute
the following: [3]:HD-CLEAR = 1, and then turn OFF and ON
the power.
3. Erase all partitions that can be initialized (all of erasable
partition data is erased)
Select the following to enter 0: [1]:CHK-TYPE = 0, and execute
the following: [3]:HD-CLEAR = 1, and then turn OFF and ON
the power.
4. Start in safe mode and format the Flash PCB, and then
reinstall the system using SST or USB.
5. Replace the Flash PCB and install the system using SST or
USB
6. Replace Main Controller PCB 1
7-61
Description
7-61