Canon imageRUNNER ADVANCE C2030 Service Manual page 774

4) Connect the terminal of the Bulkhead Unit to the position shown in the figure.
NOTE:
Check that the terminal is connected properly.
5) Install the PCI Bus Expansion PCB to the PCI Riser Support Plate by pressing the PCB
against the curved portion of the plate.
• 2 Screws (TP; M3x6) (Included in the Expansion Bus)
x2
9
Installation > Expansion Bus-F2/ IPSec Board-B2/ Wireless LAN Board-B2 > Installation Procedure > [Checking after Installation]
6) Connect the Wireless LAN Board to the connector of the PCI Bus Expansion PCB.
7) Remove the Face Plate from the Main Controller PCB. (The removed Face Plate will not
be used.)
• 3 Screws (The removed screws will be used in step 9.)
F-9-81
8) Install the 3 PCB Spacers (included in the Expansion Bus).
F-9-82
9 Installation > Expansion Bus-F2/ IPSec Board-B2/ Wireless LAN Board-B2 > Installation Procedure > [Checking after Installation]
x3
9-39
F-9-83
F-9-84
9-39