15)
Place the Control Panel temporarily in the position shown in the figure.
16)
After placing the Control Panel Connector, fix the Control Panel Cable and the Power
Supply Cable using the 2 Wire Saddles.
17)
Install the Lower Cover (small) removed in step 12.
• 1 Protrusion
• 1 Claw
x2
x2
9
Installation > Installing the Printer Cover-D2
18)
CAUTION:
• When installing the Control Panel, be careful not to hit it against the plate.
• Be sure to hold the cable when installing the Control Panel in order to prevent the
• Be careful not to pull the Control Panel because it is connected with the Control
F-9-56
F-9-57
9
Installation > Installing the Printer Cover-D2
Hold the Control Panel Cable and turn over the Control Panel.
cable from being trapped.
Panel Cable and the Power Supply Cable.
9-29
F-9-58
9-29