Canon imageRUNNER ADVANCE C2030 Service Manual page 751

■ Multi-purpose Tray Margin Adjustment (1st side: mechanical
adjustment)
1) Set papers in the Multi-purpose Tray.
2) Print from the Multi-purpose Tray, and check that the left edge margin is within 2.5 +/-
1.5mm.
Feeding direction
of paper
3) If the margin is not within the range, change the left edge margin adjustment value for the
1nd side of the Multi-purpose Tray.
As the value of COPIER > ADJUST > FEED-ADJ > ADJ-MF in service mode is incremented
by 1, the left edge margin is decreased by 0.1mm.
4) Turn OFF and then ON the main power switch to enable the setting value.
5) Write down the new adjustment value in the service label.
• ADJ-MF
9
Installation > Installation Procedure > Margin Adjustment (2nd side) > Multi-purpose Tray Margin Adjustment (2nd side)
image
F-9-30
9 Installation > Installation Procedure > Margin Adjustment (2nd side) > Multi-purpose Tray Margin Adjustment (2nd side)
■ Multi-purpose Tray Margin Adjustment (2nd side)
1) Execute duplex printing from the Multi-purpose Tray, and check that the left edge margin
for the 2nd side is within L1 = 2.5 +/- 2.0mm.
Feeding direction
of paper
2) If the margin is not within the range, change the left edge margin adjustment value for the
2nd side of the Multi-purpose Tray.
As the value of COPIER > ADJUST > FEED-ADJ > ADJ-MFRE in service mode is
incremented by 1, the left edge margin is decreased by 0.1mm.
3) Turn OFF and then ON the main power switch to enable the setting value.
4) Write down the new adjustment value in the service label.
• ADJ-MFRE
9-16
image
F-9-31
9-16