Setting C Controller Module Back To Factory-Set State - Mitsubishi MELSEC-Q Series User Manual

5
SETTINGS AND PROCEDURES BEFORE OPERATION

5.10 Setting C Controller Module Back to Factory-set State

Performing the following operation initializes the parameters files saved in the C Controller
module and sets the module back to the factory-set status.
• Executing the "Default setting" mode of the C Controller module
(
• Formatting the standard ROM of the C Controller module (
• Initializing the login user information of the C Controller module (
(1) Applications
If any of the following symptoms is identified and the C Controller module does not
operate normally, the module can be restored to the factory-set status.
This section (3))
• The C Controller module does not operate normally due to execution of a user
program registered to a script file
• The IP address or login user set to the C Controller module is unknown
Error occurred
Execute the "Default setting" mode.
This section (3)
( )
Is C Controller module
operating normally?
No
Format the standard ROM.
This section (4)
( )
Is C Controller module
operating normally?
No
Please consult your local Mitsubishi
service center or representative,
explaining a detailed description of the
problem.
Figure 5.45 Operating procedure
5.10 Setting C Controller Module Back to Factory-set State
This section (4))
Section 5.11.2)
Yes
Yes
Completed
1
2
3
4
5
6
7
8
5
- 53