Mitsubishi MELSEC-Q Series User Manual page 418

9
UTILITY OPERATION
(4) Equal assignment screen
Item
Identical point assignment
Equal assignment
LB equal assignment
Start station
End station
Start No.
Total points
assigned
LW equal assignment
Low speed LB equal
assignment
Low speed LW equal
assignment
button
OK
button
Cancel
9
- 127 9.4 MELSECNET/H Utility
9.4.6 Operating Parameter settings screen
The link device points of all stations can be equally assigned on this screen.
The start and end station values show the number of the equal assignment stations
and the setting must be within (Total link stations - (Start station No. - 1)).
(a) When "LB/LW settings" is set for "Switch screens" on "Parameter settings"
screen
Figure 9.96 Equal assignment screen (for LB/LW settings)
Table9.87 Explanation of Equal assignment screen (for LB/LW settings)
Equally assigns the input points to the link devices of each station. (Unit: 16 points)
(Initial value: "(Blank)", Setting range: 16 or more)
Equally divides the input points and assigns them to the link devices of each station.
Set the method for equal assignment to LB.
Set the first of the stations to which equal assignment will be performed.
(Initial value: "(Blank)", Setting range: 1 to ("Total stations"
Set the last of the stations to which equal assignment will be performed.
(Initial value: "(Blank)", Setting range: ("Start station" setting) to ("Total stations"
setting))
Set the start No. of the link device to be equally assigned.
(Initial value: "(Blank)", Setting range:
Set the total points of the link device to be equally assigned.
(Initial value: "(Blank)", Setting range:
Set the method for equal assignment to LW.
Set each setting item as in "LB equal assignment".
Set the method for equal assignment to low speed LB.
Set each setting item as in "LB equal assignment".
Set the method for equal assignment to low speed LW.
Set each setting item as in "LB equal assignment".
Executes equal assignment according to the settings, and closes the "Equal
assignment" screen.
Closes the "Equal assignment" screen without executing equal assignment.
* 1 "Total stations" is set in "Network range assignment" on the "Parameter settings" screen
( This section (1)).
Description
*1
setting))
This section (1)(a))
This section (1)(a))
*1