Operating Parameter Settings Screen - Mitsubishi MELSEC-Q Series User Manual

9
UTILITY OPERATION

9.4.6 Operating Parameter settings screen

This screen allows the parameter settings of the MELSECNET/H module.
(1) Parameter settings screen
9
- 119 9.4 MELSECNET/H Utility
9.4.6 Operating Parameter settings screen
POINT
1. If any entered parameter is erroneous when attempting to switch the screen
to another, a warning message appears and the screen will not be switched.
Switch the tab after correcting the erroneous parameter.
2. To update the settings into the C Controller module, write the parameters from
the <<Online operation>> tab and power off and then on or reset the C
Controller system.
3. "Link device refresh cycle" and "Routing parameter" are parameters common
to CC-Link IE controller networks.
When the set value written from the CC IE Control utility is different from the
set value in this utility, if the
operation>> tab screen, the following dialog will appear.
Figure 9.93 Parameter settings screen
button is clicked on the <<Online
Write
Figure 9.92 Dialog box