Mitsubishi MELSEC-Q Series User Manual page 446

9
UTILITY OPERATION
Item
<<Monitoring details>> tab
Transmission path switch
Loop status
Loopback station IN
Loopback station OUT
Date/time
Transient transmission error
Error code
Target network
Target station No.
Date/time
button
Save error log
button
Start monitoring
button
Stop monitoring
9
- 155 9.5 CC IE Control utility
9.5.3 Operating Diagnostics result screen
Table9.103 Explanation of Logging screen (Continued)
Displays logs in Transmission path switch and Transient transmission error.
*1
Displays transmission path switch logs.
Displays the information on the transmission paths on the entire network.
(Display item: "Normal", "Loopback", "Error in all stations")
Displays the station No. of the station where an IN-side loopback has occurred.
(Display range: 1 to 120)
Displays the station No. of the station where an OUT-side loopback has occurred.
(Display range: 1 to 120)
Displays the time at which the transmission path is switched.
*1
Displays transient transmission error logs.
Displays error codes.
For details of the error codes, refer to the following manual.
( CC-Link IE Controller Network Reference Manual)
When a transient transmission error occurs, the network No. of the error-detected
station is displayed.
(Display range: 1 to 239)
When a transient transmission error occurs, the station No. of the error-detected
station is displayed.
(Display range: 1 to 120)
Displays the time at which a transient transmission error occurred.
Saves the <<Monitoring details>> tab screen data to a CSV file.
( This section (6))
• Drive/Path: Specify where the CSV file is saved.
• File name: Specify a name for the CSV file to be saved. ( *.csv)
Starts/stops the onscreen Logging monitoring.
During monitoring, the
While monitoring is stopped, the
If a communication error occurs, the
becomes disabled.
* 1 Up to 100 logs can be displayed. If the number of 100 logs is reached, the oldest log is deleted to
record a new log.
Description
button is enabled.
Stop monitoring
button is enabled.
Start monitoring
Start monitoring
and buttons
Stop monitoring
(To next page)