Mitsubishi MELSEC-Q Series User Manual page 509

10
FUNCTIONS AND PROGRAMMING
Remark
(b) VxWorks image file
1) VxWorks image file storage location
When SW PVC-CCPU has been installed, the VxWorks image file
corresponding to one of the following models is stored.
Table10.5 VxWorks image file storage location
Model
Q06CCPU-V
C:\Melsec\CCPU\Vx\Tools\Q06CCPU-V_XXXXX-Y
Q06CCPU-V-B
C:\Melsec\CCPU\VxB\Tools\Q06CCPU-V-B_XXXXX-Y
* 1 XXXXX : First five digits of the serial No. of the C Controller module (
Y : Function version of the C Controller module (
2) When VxWorks image files do not match
When the VxWorks image file in the development environment (personal
computer) is not matched with that of the C Controller module, copy the
VxWorks image file from the system drive (/SYSTEM/OS_IMAGEFILE) of the
C Controller module to the development environment (personal computer) via
FTP.
( Section 10.2.7)
POINT
When debugging the user program after connecting Tornado, which has been
installed in the development environment (personal computer), to the C Controller
module, specify the same VxWorks image file as stored in the C Controller
module.
VxWorks
image file
Development environment
(personal computer)
If connection is made with different VxWorks image file specified, a system
watchdog timer error may occur in the C Controller module.
In addition, normal debugging cannot be done.
Refer to the Tornado manual for other debugging methods.
10.2 Programming Using Bus Interface Functions
File
Must
match !
VxWorks
image file
C Controller module
10.2.6 Precautions for program debugging
*1
*1
Section 2.5)
Section 2.5)
10
- 22
9
10
11
12
13
14
15
16